Equipment (machine) for twist-and-stir cutting

Slitting and cut-to-length line


The twist-and-stir cutting equipment (line) is used to deep cut the rolled steel into the lines (strips) of a certain width. Strips are used as blank parts in the production of welded pipes (tubes). The machine is also used to cut into dimensional sheets of specified length.

Line Composition

Basic components

  • Uncoiler
  • Slitting unit
  • Cut-to-length unit
  • Receiving table
  • Tensioning unit
  • Coiler
  • Control system


  • Coil feeding car
  • Levelling unit
  • Edge waste strip coiler
  • Unloading car
Raw Material Parameters
- Galvanized steel coils;
- Prepainted steel coils.
coil width1250 mm
coil OD600-1500 mm
coil ID500-600 mm
coil weight (max)10 000 kg
Operating Conditions Parameters
A/C net380v, 50 Hz
Compressed air net8...10 Bar
Temperature+5...+45 C
Lifting equipment10000 kg
Operation personnel2 People
Monday, 24 April 2017 11:02
ua-flag viberViberwhatsappWhatsApp+38 (068) 888-00-55 stat_ph+38 (05746) 42-388 +38 (05746) 42-389 ru-flag stat_ph+7 (916) 599-89-42 mail This email address is being protected from spambots. You need JavaScript enabled to view it.